ABAP Debugger steps

What are the steps involved in ABAP debugging?

Showing Answers 1 - 4 of 4 Answers

shabbi abbas khan

  • May 26th, 2016

In abap debugging can be done by placing a break-point at the point from where you want the program debugged or also by entering /h in the command field before executing the program

  Was this answer useful?  Yes


  • Jun 21st, 2016

In ABAP Debugging

1. In command bar /H

2. After enter the debugging select the place where we we required it mean menu set break point and press F8 Stop the program at specific line

3. Menu option break-point for at select statement or function modules etc.

4. Execute the program Display any pop up drag the file into the pop up it goes to debugging.

NOTE: In file must the type following commands: [function]

5. In program level put the break-point press F8

  Was this answer useful?  Yes

Nandkishor Jaring

  • Apr 21st, 2017

First Of all, Activate your report, then place a breakpoint where you want to debug then run/execute it by using Function Key F8.Other way is Activate your report, and in command field type /h and press Enter.After that execute your report program.

  Was this answer useful?  Yes


  • Jun 30th, 2017

You set a breakpoint wherever needed in your program(any line) and as soon as you activate and execute , it starts debugging, you can either do it line by line or set of lines together. All the time SY-SUBRC is 0 when an error occurs at a particular line the SY-SUBRC changes to 4 indicating an error.

  Was this answer useful?  Yes

Give your answer:

If you think the above answer is not correct, Please select a reason and add your answer below.


Related Answered Questions


Related Open Questions