Why condenser is needed in steam power plant?

AMIT HAZARI

• Oct 22nd, 2017

To decrease the temperature and comes to its original temperature before its inlet in turbine. If its temperature is not decreased its efficiency gets low, so finally condenser is used to increase the efficiency.

AMIT HAZARI

• Oct 22nd, 2017

Thermodynamics is a process in which energy is transferred in the form of work and head in equilibrium condition.

Answer Question  Select Best Answer

Why I section of beam are generally used?

vijay Kumar

• Jan 31st, 2014

It provides large stiffness in lateral direction and more MOI with same section.

panneerlakshmanan

 Profile Answers by panneerlakshmanan Questions by panneerlakshmanan

• May 9th, 2010

I section has lowest shape factor

Answer Question  Select Best Answer

Which is more efficient - rectangular beam or a circular beam? Give example?

Naresh Sonwane

• Mar 27th, 2016

It is all about the section modulus of the shape of member while calculating the section modulus for equal area of rectangular section and circular section, rectangular has more section modulus hence rectangular is efficient under bending stresses

PUSHP RAJ

• Oct 4th, 2014

According to material of beam if we use conc then rectangular beam but on using steel beam tubular section are better than rectangular. as construction

Answer Question  Select Best Answer

A cantilever beam is loaded a point on its ends what will be the effect in shear force?

debesh220

 Profile Answers by debesh220 Questions by debesh220

• Mar 19th, 2010

Due to the shear force the bar shows a hogging type bending moment. The shear force diagram is like a triangle triangle in +ve direction.

d_tyro_22

 Profile Answers by d_tyro_22 Questions by d_tyro_22

• Jan 27th, 2010

Considering that the load is a concentrated vertical point-load, acting on the free end of the cantilever, reaction at the rigid end can be calculated, shear-force diagram and bending moment diagrams ...

Answer Question  Select Best Answer

What happens when water flowing through pipe is suddenly cut?

kiranaimhigh

 Profile Answers by kiranaimhigh Questions by kiranaimhigh

• Jun 30th, 2011

If a pipe is of 1000 Mts in length and water is flowing through it..when the pipe is not cut..water will flow through out the 1000 Mts.. but when is it cut at around 500 Mts, the resistance offered to...

mohsinali

 Profile Answers by mohsinali Questions by mohsinali

• Feb 14th, 2010

When water flows from pipe it does have constrained motion & when supply is being cut suddenly, water particle tends to continue its motion but it doesn't so. Therefore the pressure wave is been g...

Answer Question  Select Best Answer