How do you analyze results and report the defects?

Following each test run, WinRunner displays the results in a report. The report details all the major events that occurred during the run, such as checkpoints, error messages, system messages, or user messages. If mismatches are detected at checkpoints during the test run, you can view the expected results and the actual results from the Test Results window. If a test run fails due to a defect in the application being tested, you can report information about the defect directly from the Test Results window. This information is sent via e-mail to the quality assurance manager, who tracks the defect until it is fixed.
  • Interview Candidate
  • 4
  • 1887

Showing Answers 1 - 4 of 4 Answers

nagarjuna

  • Jun 7th, 2006
 

 

By examining the results we send the reports

  Was this answer useful?  Yes

pravin08

  • Jun 19th, 2007
 

The test result contains information about the steps which are pass and failed due to defect in the AUT. If there is any mismatch in the checkpoints it is also reported as fail in the result. Based on this we can report the defects to QA manager through mail or report the defects in Quality Center.

  Was this answer useful?  Yes

Give your answer:

If you think the above answer is not correct, Please select a reason and add your answer below.

 

Related Answered Questions

 

Related Open Questions