-
Junior Member
Errors after compilation
Hai,
When we compile a procedure, if there is any error, it shows "Warning: Procedure created with compilation errors." We have to type explicitly, "show errors" in order to see the errors. Is there any way that the errors are shown implicitly after compilation?
-
Expert Member
Re: Errors after compilation
It wont show errors during compilation. it will create procedure with errors.
there is no other way too. (other than show errors)
but when you execute that procedure, it will shows those error.
-
Contributing Member
Re: Errors after compilation
hi,
Really a good question. weel there is not a permanent solution. but u can do one thing, after the END stmnt. of procedure give a forward slash, and then write show err; and again give forward slash. and then compile the whole fiel, if some error is there it will display errors.
--write code here--
end procedure_name;
/
show err;
/
now compile whole file.
regards,
RSY
-
Junior Member
Re: Errors after compilation
This looks better.
Thanks Raghav!!!
---------
Bhuvana
-
Contributing Member
Re: Errors after compilation
hi,
Bhuvana, click on the thanks button if u want to say thanks, that will add to my reputation.
ok, and one more thing, if u are using the suggestion which i gave, in real time, then remember one thing, i.e. to delete the show err; code from the file, before doing the checkin to the version control.
ok, do not forget this.
regards,
RSY
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules