-
Junior Member
QTP and .net 3.0 applications.
Hi everybody, its my first post, so excuse any mistakes on my post. I've tried to record a .net 3.0 application with QTP 9.1 (+ .net 9.1 addin) and with QTP 9.2 (= .net 9.2 addin). In both cases the recording was not right. Does QTP support .net 3.0? Any suggestions?
Thanks in advance!
-
Expert Member
Re: QTP and .net 3.0 applications.
Kindly check the record mode this will happen only when u record in low level
and plz make sure...application is opened after QTP is opened...Please let me know
-
Expert Member
Re: QTP and .net 3.0 applications.
HP Mercury QuickTest Professional uses the QtPro.exe.config to specify the .NET Runtime version that should be used for automated testing. If QTP isn't configured to use the correct version of the .NET Runtime, you will encounter problems during the recording or replaying of scripts.
-
Expert Member
Re: QTP and .net 3.0 applications.
check this...
Locating the QtPro.exe.config file
The QtPro.exe.config file in located in the "bin" subdirectory where QTP is installed. For QTP versions 8.2, 9.0, 9.1, and 9.2, the default location of this file is the following path:
C:\Program Files\Mercury Interactive\QuickTest Professional\bin\QtPro.exe.config
-
Expert Member
Re: QTP and .net 3.0 applications.
Updating the QtPro.exe.config file
Open the QtPro.exe.config file using a text editor of your choice, using the information in Locating the QtPro.exe.config file section above.
In this file, you must ensure that the correct version of the .NET Runtime is in use. Only one version can be selected at a time. If your program is a .NET 2.0 application, you must use the version "v2.0.50727" of the .NET Runtime; the version of NetAdvantage for .NET used in the application must be a "CLR 2.0" version. If your program is a .NET 1.1 application, you must use the version "v1.1.4322" of the .NET Runtime; the version of NetAdvantage for .NET used must be a "CLR 1.x" version, or must be "2005 Volume 2" or earlier.
Below is an example of the contents of a QtPro.exe.config file set to target version 2.0 of the .NET Runtime. It also includes information for version 1.1 of the .NET Runtime, but this information is commented out and thus not used.
-
Expert Member
Re: QTP and .net 3.0 applications.
-
Junior Member
Re: QTP and .net 3.0 applications.
Hey,
I am facing similar issue with QTP 10 and .Net 3.5.
Please let me know if somebody has resolution.
Thanks,
Parveen
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules