Latest Answer : A engine in which combustion cycle completes within 2 rev of crank or 4 strokes of the piston is known as 4 -stroke engine. ...
Latest Answer : When we talk about efficiency then 4-stroke is better than 2-stroke. Although for same size of engine power of 2-stroke is more b'coz in one revolution of crankshaft one power stoke is produced. For same amount of power 2-stroke is lighter but altogether ...
Latest Answer : If you tame an elephant for transporting goods rather than using a donkey - the elephant will transport more goods at a time, but will require more food. Elephant = bigger CC engine, More goods = more power or output, more food = More fuel consumption ...
Latest Answer : Sir,For increasing the power requirement we need to increase cubic capacity of liquid.RegardsPradeep Khanduja ...
Latest Answer : DTS-Fi stands for "Digital Twin Spark Fuel Injection", a ‘Bajaj Patented Technology’. In fuel injection, the conventional carburettor has been replaced by injector which injects fuel in to the engine in a spray form based on the ...
Latest Answer : in CI engines...the kinetic energy which is lost during braking is partially recovered by a simple change in the cylinder design.....an additional valve called charging valve which leads to a separate air chamber ....now wen the vehicle needs a stop,...the ...
How do isolation springs (mounts) react to engine RPM (can they be calibrated to "stiffen" as RPM increases)
Latest Answer : There is two procedure for engine testingOne for IC engine testing at EOL (End of Line)
another for IC engine testing for Quality assurance.In 1st testing defects in the engine assembly can find out.
In 2nd testing I.P. B.H.P can test as per design ...
stroboscope is used for measuring1. rpm of the spur gear2. temperature calibration3. velocity of the reciprocating engine4. all the above5. None of the above
Latest Answer : velocity of reciprocating engine ...
for uniform strength of beam condition req.A. Depth constant, width increases.B. Depth increases, width decreases.C. Both should increase.D. All the above.E. None of the above.
Latest Answer : cross sectional area is to be decreased towards the support. this can be achieved by:a)keeping the depth constant and varying the widthb)keeping the width constant and varying the depthc)varying both the depth & width ...
