 Related Questions A communications protocol used to connect computers to remote networking services including Internet service providers. Latest Answer : In networking, the Point-to-Point Protocol, or PPP, is a data link protocol commonly used to establish a direct connection between two networking nodes. It can provide connection authentication and can also provide transmission encryption privacy and ... The data unit in the LLC level is called the protocol data unit (PDU). The PDU contains of four fields a destination service access point (DSAP), a source service access point (SSAP), a control field and Latest Answer : each layer or the osi model , formats the data that it receives , the package of data moves through the layers is called protocol data unit. the protocol dat unit name associated with each layer of the osi model layers ... Repeater:Also called a regenerator, it is an electronic device that operates only at physical layer. It receives the signal in the network before it becomes weak, regenerates the original bit pattern Latest Answer : Different type of networking / internetworking devicesRepeater:Also called a regenerator, it is an electronic device that operates only at physical layer. It receives the signal in the network before it becomes weak, regenerates the original bit pattern ... Every line has an upper limit and a lower limit on the frequency of signals it can carry. This limited range is called the bandwidth. Latest Answer : Hi,Its capacity of transimitting media. ... ICMP is Internet Control Message Protocol, a network layer protocol of the TCP/IP suite used by hosts and gateways to send notification of datagram problems back to the sender. It uses the echo test / The address resolution protocol (ARP) is used to associate the 32 bit IP address with the 48 bit physical address, used by a host or a router to find the physical address of another host on its network Latest Answer : The adress resolution protocol (ARP) associates an IP address with the physical adress. On a typical physical network (eg: LAN) each device on a link is identified by a physical or station adress usually imprinted on the network interface card(NIC)Physical ... Class A 0.0.0.0 - 127.255.255.255Class B 128.0.0.0 - 191.255.255.255Class C 192.0.0.0 - 223.255.255.255Class Latest Answer : class A 1 - 126 . class B 128 - 191.class C 192 - 223.class D 224 - 239.class E 139 - 246. ... It is a protocol formerly used to exchange routing information between Internet core routers. It is a host that has a multiple network interfaces and that requires multiple IP addresses is called as a Multi-homed Host. Latest Answer : If more than one NICs (Network Interface Card/ Network Adapter) are installed having different IP Addresses onto it, The Pc Becomes a Multihomed Host. ... It is an Internet routing protocol that scales well, can route traffic along multiple paths, and uses knowledge of an Internet's topology to make accurate routing decisions. Latest Answer : hi,OSPF is Open shortest path first, basically comes into the category that uses link state as the routing info communication. OSPF is used in a particular Autonomous system, not used on the internet but its limited to internal routing in an organization.On ...
Sponsored Links
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
